Tennis Ball Tripod

Step 1 Mark and Cut

Cut the ball in half with an kitchen scissors, a craft knife, or even a kitchen knife.

Wear good safety goggles. Blades can slip or snap.

Mark three tripod feet on the edge of the ball with a pen or pencil.

Each flat foot is about 3/4 inch (18mm) wide.

There should be about 2 inches (50mm) between the edges of the feet.

Cut arches between the feet to make the basic tripod shape. Arch size and shape are not important.

Cut a 3/4 inch hole in the top of the ball.

Optional step: cut a side slit in the top hole for more tilt.
Optional step: make bungee cord holes above each foot.

Scroll down below the photo and click the other pictures for this step.