Print PDF
Favorite
Email
Step 3Assemble
Buy a 1 inch plastic bolt, 25 cents at Home Depot.
It should be 1/4 inch diameter and have 20 threads per inch. This is close to the standard camera mount size. Since the bolt is soft plastic it will not strip or damage your camera.
Push the bolt through a washer so it sticks out of the felt side.
Then put the bolt through the tripod base from underneath.
And finally press the other washer on the top.
Now you can screw the tripod into the mounting hole on the bottom of your camera.
Scroll down below the photo and click the other pictures for this step:
It should be 1/4 inch diameter and have 20 threads per inch. This is close to the standard camera mount size. Since the bolt is soft plastic it will not strip or damage your camera.
Push the bolt through a washer so it sticks out of the felt side.
Then put the bolt through the tripod base from underneath.
And finally press the other washer on the top.
Now you can screw the tripod into the mounting hole on the bottom of your camera.
Scroll down below the photo and click the other pictures for this step:
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Mar 12, 2010. 12:25 PMrobotmastern
says:
actualy 1/4-20 is the standard size. so you could use aluminum.
Reply
 |
Add Comment
|
