Print PDF
Favorite
Email
Step 8Build the Guard
Having a guard with a spinning saw blade is very important! (thanks to everyone who kept reminding me of this idea.)
I started with a 7-1/4 inch Skilsaw inner guard and hack-sawed a piece off to make it conform roughly to the CD Case. Then I hot-glued it into position where it touched at various points of the CD Case, and at the connector that goes to the PVC inlet pipe. Check clearances as you go so the blade is centered in the guard.
I started with a 7-1/4 inch Skilsaw inner guard and hack-sawed a piece off to make it conform roughly to the CD Case. Then I hot-glued it into position where it touched at various points of the CD Case, and at the connector that goes to the PVC inlet pipe. Check clearances as you go so the blade is centered in the guard.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
