It should take about 3 minutes to make an extremely practical, durable and waterproof wallet that looks better as it gets older!
Step 1: Choosing your design
Open the top of the carton fully.
The most important step is organising how the wallet will look when finished and this is the first decision to make.
You will need to choose what face of the carton will be on the outside of the wallet and which will be on the inside. With the carton standing upright choose a surface that will be the outside (the one that everyone will see and comment on), the inside face of the wallet will be the surface directly to the right of the wallet's outside face [see picture]. The other two faces will not be seen, but will be used for folding and will make the wallet more durable.
Step 2: Cutting the template
Cut the bottom and top carton flaps on all edges except for the flaps connected to the inside face of the wallet [see second and third pictures].
Cut a small 5mm section off the top of the inside pocket to allow the pocket to be folded in. [see fourth picture]
Open out flat so that the template matches the one in the fifth picture.