This instructable is made for those who know how to solder (well) and how to program the Arduino. Also I will be providing detours to skip sum steps so if you see (Detour available skip to __ Step) you can follow if you are to lazy to do that.
Step 1: Get the materials
-- 64 LED (color optional) **
-- Arduino Demulionove
--32 male pin strip
--PCB prototype board
--Fine Grit (400 +) sand paper
-- 64 resistors or 16
you can get 64 resistors which will help by keeping all the lights at the same light out put regardless of how many are on but it will be considerably more work.
--thin nose pliers
**Color is optional but use this website to find the right resistor for your leds http://led.linear1.org/led.wiz (I got Green so I used 100 ohm resistors)
Step 2: Assemble the board(the LED cube base)
In this step you will need the board and the wiring. First you will want to map out were all the wires will go and then feed the wires through the board. Don't mind the LED and resistor note on the picture for now.
NOTE: I recommend you use Different color wire just because you won't get confused which wire is which.
Step 3: Defuse the LED
So to defuse the LED I took normal 400 grit sand paper and sanded all the LEDs which made them look pretty good.