Introduction: The Alaskan Scrambler

Picture of The Alaskan Scrambler

Do you need to race across the Alaskan tundra to help a injured friend? Just put this little ATV together and you'll get to your destination.

Step 1: Gather Your Parts.

Picture of Gather Your Parts.

Setting up your parts in this order is not super important, but it is handy.

Here are the links to the Lego sets that I used parts from.

Fire Chief Car

Arctic Snowmobile

Step 2: Assemble the Wheels and Skis.

Picture of Assemble the Wheels and Skis.

Step 3: Install the Skis and the First Set of Wheels.

Picture of Install the Skis and the First Set of Wheels.

Step 4: Put the Black Piece on the Wheel Base.

Picture of Put the Black Piece on the Wheel Base.

Step 5: Add the Orange Piece, and Install the Whole Unit to He Main Chassis.

Picture of Add the Orange Piece, and Install the Whole Unit to He Main Chassis.

Step 6: Put the Main Piece for the Front Together.

Picture of Put the Main Piece for the Front Together.

Step 7: Put the Outer Trim Piece On. and Install the Headlights and the Handle Bars.

Picture of Put the Outer Trim Piece On. and Install the Headlights and the Handle Bars.

Step 8: Install the Unit That You Just Built.

Picture of Install the Unit That You Just Built.

Step 9: Build and Install the Tail Light Ensembly.

Picture of Build and Install the Tail Light Ensembly.

Step 10: Add the Black Piece.

Picture of Add the Black Piece.

Step 11: Install the Rear Fenders.

Picture of Install the Rear Fenders.

Step 12: Put on the Angle Plates.

Picture of Put on the Angle Plates.

Step 13: Put on the Engine.

Picture of Put on the Engine.

Step 14: Install the Roll Bar.

Picture of Install the Roll Bar.

Step 15: Put on the Little Grippy Guys.

Picture of Put on the Little Grippy Guys.

Step 16: Put Tools in the Grippy Guys.

Picture of Put Tools in the Grippy Guys.

Step 17: Snap on the Chain.

Picture of Snap on the Chain.

Step 18: Install the Control Panel.

Picture of Install the Control Panel.

Step 19: ALL DONE!!!

Picture of ALL DONE!!!

Comments

About This Instructable

290views

5favorites

License:

Bio: I'm a high school student who loves making and hacking stuff!
More by BikeHacker:Wendy's Frosty Imitation How to Make a 3D Printed Fidget Spinner Using Fusion 360 How to Make a Ring From a Nut in 30 Minutes
Add instructable to: