The BO-AT Single Sheet Plywood Boat

Step 2 Cutting out the parts

In the video link for the first page you can see how to cut out the various parts for the boat.  You will need to make the following cuts:

1 - 24 inch by 96 inch sheet for bottom, bow and stern - this part we further cut into three parts:

1 - 18 inch by 24 inch part for the bow
1 - 12 inch by 24 inch part for the stern
1 - 24 inch by 66 inch part for the bottom

2 - 12 inch by 96 inch sheets for the sides - will be further cut to match the angle of the bow while assembling

3 - 1 inch by 2 inch by 8ft boards for supports - cut to size

1 - 1 inch by 3 inch by 8ft board for trim on bow and stern

2 - 1 inch by 2 inch by 8ft boards for deck - cut into 24 inch planks and then threaded with 550 paracord for deck