Print PDF
Favorite
Email
Step 4Making the Angle Guide
Now since 60 degree angle guidess aren't exactly common place its time to make a smaller version.
Change the angle on your table saw to 30 Degrees. Set your width on your saw guide to 2 inches.
Again flip it over and put it through the saw so you put the same angle on the opposite side so both sides of the wood have the same 30 degree angle.
Cut this pieces into six individual 3 inch strips.
We do this because a smaller set is much easier to hold together to glue.
Change the angle on your table saw to 30 Degrees. Set your width on your saw guide to 2 inches.
Again flip it over and put it through the saw so you put the same angle on the opposite side so both sides of the wood have the same 30 degree angle.
Cut this pieces into six individual 3 inch strips.
We do this because a smaller set is much easier to hold together to glue.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
