The Bischoff 720 A.T.S (Accurate Targeting System)

Check my Scorpion 360 C.D.M too!

Here it is: The Bischoff 720 A.T.S

This is my biggest and most sweet knex gun, and the shooting system is inspired on Killerk's firing system
It has a range of at least 175 ft and the accuracy is up to 110 ft!
I think it's my personal best because of the range.
Very fun when sniping on targets.

Pros:

-Kick ass design
-Can pierce a bucket from a distance of 3.5 m
-True trigger
-Two handles
-Very accurate
-Very powerful

Cons:

-The bipod isn't foldable

For short:
It's a very recommandable sniper rifle.

Step 1: Collecting Materials

Rods:
12 greys
8 reds + 1 red (bullet)
7 yellows
29 blues
114 whites
108 greens

Connectors:
110 yellows
44 greens
18 light greys
28 oranges
22 greys
32 reds
6 whites
2 dark blue

Exotics:
1 tan clip
2 metallic blue clips
3 y-shaped connectors
8 blue spacers
2 gray spacers

Also needed:
2 rubberbands
1 snapped rubberband
1 small rubberband
normal tape
duck tape

This is what you'll need to make the gun.

Step 2: Upper Stock

This part isn't necassery but it makes the stock a lot more resistance proof.

Step 3: Bullet Holder

This part is for letting go of the bullet when you pull the trigger.

Step 4: The Barrel

The most time consuming and finger torturing part of the gun, but it's necassery.

Step 5: The Trigger

This part is very necassery, assuming that it locks the bullet in place

Step 6: The Bi-Pod

This part isn't necassery but it comes in handy when sniping because you will have a stable base to aim.

build it twice.

Step 7: Rubberband Shooter

This part is to tie the rubberband in place and so that you can pull back the band.

Step 8: Stock

This part is pretty important for looks, strength and, it makes a comfortable handling when shooting.

Pic 5 needs to be built twice.

Step 9: Barrel Bars

This part is required because if you would'nt put it on, the barrel would be all shaky and that's a less accurate shot, which is annoying.

Step 10: Handle Bars

These parts are for a more comfortable handling of the gun.
and they spare you some painful fingers.

Step 11: The Bi-Pod 2

Connect the two bi-pod sides as shown.

Step 12: Putting Together the Barrel

pic 1: get the pieces
pic 2: bullet holder + barrel
pic 3: put them together
pic 4: barrel + barrel bars
pic 5: put them together
pic 6: rubberband holder + barrel
pic 7: put them together

Barrel Completed.

Step 13: Trigger + Barrel

Connect the trigger as shown on the pics.

Step 14: Trigger + Stock + Handles

pic 1: Trigger + Stock
pic 2: Put them together.
pic 3: Trigger and Barrel + Handles
pic 4: Put them together.

Basic model completed.
View next steps on how to load, which ammo you should use, how to put the trigger rubberbands and how to assemble the Bi-Pod.