loading
Picture of The Box Transformer
DSC04615.JPG
this is a box transformer. it transforms into a box again. all out of cardboard and hot glue and a few cardboard staples i found on a box. (99% recycled) the hot glue isn't recycled.
 
Remove these adsRemove these ads by Signing Up

Step 1: Items

Picture of items
you will need a cardboard box you can fit in, a knife, hot glue, and 8 cardboard staples.

Step 2: Body and legs

Picture of body and legs
DSC04612.JPG
cut along one side of the box so its as long as possible and flat. put one flap up and mark were your feet are going to be. then cut a line in the middle to where your thigh so you can walk. then put a piece of card board over the feet (see pic)

Step 3: Arms

Picture of arms
cut off 2 flaps ether side of each other around were your arms would be. the get 2 strips of cardboard  a little longer than the width of the flap.

Step 4: Head

Picture of head
take the 2 flaps where your heat will be and fold them so you can put a square on top and glue it.

Step 5: Tansforming back into a box

Picture of Tansforming back into a box
DSC04615.JPG
just crouch down and let every thing fall in  place