I was given my first AR-7 in 1972 as a Christmas present from my older brother and I kept it until the late 1990's when the receiver got badly dented, the stock destoryed, and magazine just gone after a 1300 foot fall during airborne operations when my ruck sack got torn on exit from the aircraft.
The AR-7 used in this Instructable was given to me as an early Fathers Day present by a buddy of mine from my Army days a few weeks ago. As you can see, it too has seen some wear and tear over the years and does need to have the stock replaced (which is on order) and it could stand a coat of paint which it will be getting once the new stock comes in.
The original owners manual that came with the AR-7 was vauge on the proper care of the weapon. It lacked any good, detail photos or illustartions on how to take the internal parts out to facilitate removal of the bolt for claening. I hope that this Instructable corrects that problem.
The steps in this Instructable should translate to any of the AR-7's produced by the various manufacturers.
Step 1: The AR-7
The main parts of the AR-7 are the receiver, barrel, magazine, stock, and butt plate.
The rifle fires the .22 cal long rifle cartridge and can be a little finicky when it comes to what brand of ammo it fires. This particular AR-7 fires without any problems with CCI Stingers and Remington high velocity hollow points. Any other bards of ammo tend to cause jams after 2-3 rounds, as do any brand of flat nosed bullet. The feed problems seem to cross all of the older AR-7 platforms.