With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
The Dawm is a breakout board for the TLC5940 chip. This chip has the possibility to pwm (pulse width modulation) 16 different ports over serial commun...
The things that is needed to finish this is1 The Dawm (breakout board) available now by mailing me or soon from here http://blushingboy.org/ 1 TLC5940...
Solder the socket which will hold the chip in place. Make sure to line up the "halfmoon" on the socket and the graphic on the card to guide you in whi...
Solder the female pinheader which enables easy and fast connection to your LEDs. One possible solution here could be to solder the LEDs or cables goin...
Solder either female or male pin headers to the side of the boards. The decision between female and male depends on your setup. If you want to stack t...
Solder the Resistor on its place. It doesn't matter which direction it goes in. The size of the resistor depends on how much current you are going to ...
Now you are done with the soldering of the board and it is time to control it with some code.On the Arduino playground you can find a library called T...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »