Instructables

The One Dollar Ring

Picture of The One Dollar Ring
In this instructable you will be learning how to construct your very own one dollar bill ring.

Materials needed:

1. One, One dollar bill. ( Any bill can be used )
 
Remove these adsRemove these ads by Signing Up

Step 1: Step One

Picture of Step One
068.JPG
Begin with the word ONE facing you. Meaning poor ol' Washington is facing down.

Fold the white border at the top of the bill towards the other side. Crease gently.

Do the same for the bottom border as well.

Step 2: Stetp two

Picture of Stetp two
070.JPG
072.JPG
Now, Fold the bill in half lengthwise. Crease firmly.

Then fold bill precisely in half lengthwise again. Crease firmly.

If you have folded correctly, the ONE symbol on the ends will be framed evenly along the top and bottom.

Step 3: Step Three

Picture of Step Three
074.JPG
075.JPG
Pick an end with the ONE symbol and fold the white border at the edge back.

Then fold the entire ONE symbol so that it is again evenly framed in a square at the other side of the bill like indicated in the picture.

Step 4: Step Four

Picture of Step Four
Now, with the ONE symbol facing you and upright, bend the bill in half upwards like indicated in the picture. You are left with an L shaped bill.

Step 5: Step Five

Picture of Step Five
078.JPG
079.JPG
080.JPG
Once you have the L shape, begin curving the bottom end around with the ONE symbol facing outwards.

Curve ONE symbol towards the 90 degree corner where the bill is bent up like indicated in picture 3.

You should now have whats shown in picture 4.

Step 6: Step Six

Picture of Step Six
096.JPG
097.JPG
090.JPG
Now after lifting the ONE symbol flap, wrap the excess bill around the body of the ring until none is left over like indicated in pictures below.

Step 7: Step Seven

Picture of Step Seven
092.JPG
Once excess bill is wrapped around completely. Bring over the ONE symbol over the body of the ring like indicated in picture 1, and tuck in the white corner edge into the body of the ring.
julibells11 months ago
Didn't work,
joshuao1 year ago
That is a great after note
Stone_UFO1 year ago
cool
I just can't figure out step 5. I made the 90 degree angle and curve the side. It looks JUST like your picture but I can't figure out step 5, image 3. I'll keep working on it.
usded993 years ago
OMG!! Great!!! just made one!
lemonie5 years ago
It's a classic (I count 4 other Instructables on the same thing) but you've presented it very well, good job. L
foo232205 years ago
Amazing job. Not quite sure how you folded it in step 2. I didn't fold it the exact same, but it still comes out well, just with a different image on the ring band. 5/5