The Real Bullet Necklace or Earring

Step 2 Getting rid of the firing cap

NOTE: The author is not in any way responsible for any harm anyone could possibly cause upon themselves, anything, or anyone else by doing this process.

The best way i figured to get rid of the firing cap is to place it on a concrete surface, *like my garage floor* AWAY FROM ANYTHING FLAMMABLE. Place it Cap side up, with the opening where the bullet was on the ground. I then took a metal punch and stuck it with a hammer while the punch was sitting on the cap making it fire off on to the concrete. I then took the metal punch and pounded out the remains of the firing cap out the back by placing the punch on the inside of the casing, leaving a hole in the back of the casing.

Comments

[HmOnGbOi]

aye how did u take off the primer off

[lpdunwell]

aye read the instructable [insert insult here]

[jacob5680]

I used to make these all the time, I simply use casings with primers that have already been fired, and I make my own bullets, but that may be out of the question here...
Great Instructable, tho this step may be iffy by some. as you pointed out. =P

[bpfh]

Except your own home made heads are molded lead and not copper FMJ... Not the most healthy thing to have rubbing against your skin...