Print PDF
Favorite
Email
Step 25Mount the components
The components have been soldered on to the board:
The seven pins making up crystal and programming sockets.
Two capacitors around the crystal
A 10K resistor pulling up the MCLR line to Vdd
A supply decoupling capacitor across Vss and Vdd
Two links have been soldered into place, and one more has to be fitted.
The lands for fitting the integrated circuit have been coated with solder prior to fitting it in position.
The seven pins making up crystal and programming sockets.
Two capacitors around the crystal
A 10K resistor pulling up the MCLR line to Vdd
A supply decoupling capacitor across Vss and Vdd
Two links have been soldered into place, and one more has to be fitted.
The lands for fitting the integrated circuit have been coated with solder prior to fitting it in position.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Oct 31, 2009. 2:25 PMadnimo
says:
Dude... that's the worst soldering I've seen in a long while, even worse than my very first soldered joint... and it was a cold one, damn! you need a) better tip b) more power c) practice the tin feeding and timing, you're not doing it properly. always lift on the same direction and feed enough to solder A and B, if not you have the potential of soldering X as well and with your thin traces that's very possible.
Reply
 |
Add Comment
|
