Instructables

The Snow Ripper - Rip snow from your roof in minutes. 1/2 Snow rake - 1/2 Ripper / Cutter.

FeaturedContest Winner

Step 8: Step 8

Picture of Step 8
8B.JPG
8C.JPG
Take the sheet metal and cut out a notch according to the photo and screw into the 1” header and ½” support pipes using 10 screws. Measure from the right 11 1/8 inches and to 12 7/8 inches. Mark these measurements. Measure 1 inch in as seen in the photo.  Cut with sheet metal shears the two line.  Bend the cut piece to 90 degrees.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!