Well I guess I'm back
this is one I had planned back for September
and I like how stable the base is so here you go
Step 1: Materials
So here you go
tape or hot glue
Step 2: The barrel
Tape or glue the two straws together as shown
Step 3: The Sight
cut aproximatly an inch off of the third straw. Then cut 2 1/2 centimeter lengths to stand the scope. Glue or tape together as shown. Mount, then cut a small sliver bend it tape it under the scope to make a crosshair.
Step 4: The Stand
cut two centimeter pieces at a diagonal and tape them on the front of the bottom barrel with the diagonal pointed so it lines up with the table as shown.
Step 5: The Stock
cut one length one and tape it under the extra at the end of the gun.