The UberWallet

My UberWallet.

2 cash pockets,2 credit card holders, and the possibility for ultimate modification (see my bus pas holder, chage pocket mod at the end)

To make this masterpiece you will need -

one (1) piece A3 paper (the thinner the better, thin newspaper works really well)
one (1) sheet sticky back plastic about 36 cm * 24 cm (you can use tape but its far more fiddley)
one (1) small sharp craft knife.
NO ruler needed (after measuring out the sticky back plastic anyway)
A little folding skill

Step 1: First Folds

1, Fold the paper into half and half again and open back out both horizontally and vertically. this will give you 16 equal rectangles.
Then, fold a 'lip' at the top edge about 1-2 cm down

Comments

[15zhangfra]

Nice instructable, really like it. Slightly more complicated than the other paper wallet, but this looks really cool.