Print PDF
Favorite
Email
Step 3Prepare the thread pegs
Use the bolt cutters to cut apart the belt and tie racks.
Snug the cutters up against the inside of the vertical support furthest from the edge. (See the picture with the bolt cutters.) Doing this on both sides will result in approximately the right width for one of the rods.
To cut the other rod, position the cutters not quite snug against the first of the pegs.
Now try fitting the rods into the wooden trim inside the box. Cut the rods down further as required, but don't make them so short as to fall out of the wooden trim when everything is tucked into place.
Snug the cutters up against the inside of the vertical support furthest from the edge. (See the picture with the bolt cutters.) Doing this on both sides will result in approximately the right width for one of the rods.
To cut the other rod, position the cutters not quite snug against the first of the pegs.
Now try fitting the rods into the wooden trim inside the box. Cut the rods down further as required, but don't make them so short as to fall out of the wooden trim when everything is tucked into place.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
