Step 2: WoodWorking

First, Take your dowel and cut off about 1/2 inch off of the end.
Then sand the tops until they are smooth.
Sand the sides so it is still a circle but thinner.
I don't think that piece of wire is going to be hard enough to do much with. Why not use a small allen wrench, grind off the short leg,drive it into the wooden handle and sharpen the end. Be careful not to over heat the metal while sharpening so it stays good and hard. Now you have a screwdriver that will last a while! You could togten the shaft in a drill chuck and use sand paper to shape the handle. Use coarse to fine sand paper then dip it in some polyurethane to make the handle look good and last a long time. Make a whole set with different size shafts.
I would suggest flattening the other side as well and hammering that into the dowel to prevent movement. If you really have fine parts to work with though, I'd suggest just buying for a precision screwdriver set because they cost less or about the same than the materials listed on this Instructable and have more versatility.
Its more fun to DIY though!
Not arguing with that! :)
:) you do have a point though
Thank you! <br>One use! <br>
Tiny screwdrivers are great for repairing reading glasses.

About This Instructable


3 favorites


Bio: I LOVE knots. As well as other things. I post random 'Ibles not even related to knots. Sorry if there's a delay of when ... More »
More by ThatKnottyguy: How to mix CGD (Crested Gecko Diet) Xbox Mods & Repairs Part 5 of my knot series: The Highwaymans Hitch
Add instructable to: