Print PDF
Favorite
Email
Step 6Mount the Guide
The key to this step is being "square." Ultimately what is important in this step is to ensure that the guide and the saw blade are as close to being parallel as possible. I mounted my saw on the panel and then proceeded to take measurements.
Lower your blade through the precut slot as far as it will allow.
Use a scale to create marks as equal distances from the blade at the front and at the rear. Mark a line between the marks to act as an alignment for the guide.
When you are ready, apply glue to the bottom of the guide and to the top of the panel and clamp in place.
Lower your blade through the precut slot as far as it will allow.
Use a scale to create marks as equal distances from the blade at the front and at the rear. Mark a line between the marks to act as an alignment for the guide.
When you are ready, apply glue to the bottom of the guide and to the top of the panel and clamp in place.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
