Print PDF
Favorite
Email
Step 7Glue In Switches
Apply the Goop or Shoe Goo adhesive to the areas on the circuit board you ground flat, then place switches in the glue with the side that has the remaining leads facing upward. The round buttons should face the tuning wheel with a piece of thin cardboard in between them both to create a small gap. I used some cut-up pieces of the battery packaging.
Then apply more adhesive to the backs and sides of the switches being careful not to glue the button part so it won't press. Be sure to leave the two contact leads exposed.
Apply some masking tape to hold the switches in place for 1/2 hour, then remove it as well as the shims and let dry overnight.
Then apply more adhesive to the backs and sides of the switches being careful not to glue the button part so it won't press. Be sure to leave the two contact leads exposed.
Apply some masking tape to hold the switches in place for 1/2 hour, then remove it as well as the shims and let dry overnight.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
