TrapR

234

1

1

Published

Introduction: TrapR

Most of the time the ball is being shot around. But sometimes it gets trapped! The TrapR holds the ball until it gets enough input to push out the ball again. It even knows when it has caught a ball and might provoke some negative points...

Step 1: Invent

Sadly, my concept didn't work out. I tried to push a platform by using a kind of rotating screw, but it wouldn't properly push up. The platform got caught in the rails or the screw disattached from the servo.

Maybe it is possible to use gears-wheals and a gear rack to implement the movement?

The module would need a mikrocontroller to operate the servo. For testing purposes I used an Arduino outside of the module, but idealy you would put a small controller inside the module that accepts analog input.

You can use the files attached below. The .svg is quite complicated. Use the photos above as a guide to assemble this (not well functioning) variant.

Share

    Recommendations

    • Casting Contest

      Casting Contest
    • Woodworking Contest

      Woodworking Contest
    • Planter Challenge

      Planter Challenge
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    Comments