Print PDF
Favorite
Email
Step 2Assemble
Before assembling inspect the corner braces. If they aren't quite 90 degree angles bend them a little so that they are pretty close.
Start by attaching the three braces as shown with the non-thumb screw, four nylon washers, and a lock nut. Don't tighten the lock nut all the way down. Leave it loose enough that you can rotate the mending brace, but tight enough that it will stay where you put it.
Next, attach the thumb screw to the other hole of the mending brace with the other lock nut and at least one washer on either side of the brace. Orient the screw so it is facing the opposite direction of the first screw, unlike in the photo (so that the first screw doesn't get in the way of the camera). Tighten similarly.
Start by attaching the three braces as shown with the non-thumb screw, four nylon washers, and a lock nut. Don't tighten the lock nut all the way down. Leave it loose enough that you can rotate the mending brace, but tight enough that it will stay where you put it.
Next, attach the thumb screw to the other hole of the mending brace with the other lock nut and at least one washer on either side of the brace. Orient the screw so it is facing the opposite direction of the first screw, unlike in the photo (so that the first screw doesn't get in the way of the camera). Tighten similarly.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
