Introduction: Trendy Ring From Bottle of Soap!

Picture of Trendy Ring From Bottle of Soap!

Equipment list required:

-detergent in plastic bottle

-models from which to take inspiration

-markers tempera and / or colored pasta (gutta)

-sheet of paper

-pencil and eraser

-glue or Uhu Pattex

-scissors

-sandpaper

-gloves

-lighter

Official Website: http://creiamo3d.it/tutorial-anello-alla-moda-da-...

YouTube channel: https://www.youtube.com/channel/UCHZW-2zG-U-AMWcd...

Facebook page: https://www.facebook.com/Creiamo3d/

Instagram: https://www.instagram.com/fablab_creiamo_in_3d/

Twitter: https://twitter.com/Creiamoin3D

Step 1: Wash the Entire Bottle

Picture of Wash the Entire Bottle

Choose the bottle you want and with the special gloves wash it under running water.

Step 2: Rub the Bottle

Picture of Rub the Bottle

Dry the bottle with a tissue.

Step 3: Cut the Bottle in Half and Dry the Inside

Picture of Cut the Bottle in Half and Dry the Inside

With scissors, starting from the top, cut the bottle in half and dry well the inner parts.

Step 4: Choose the Models and Bring Them on Paper

Picture of Choose the Models and Bring Them on Paper

Choose the model that you want to create and draw them on the sheet, possibly even color them.

Step 5: Crop Models Created

Picture of Crop Models Created

Cropped accurately models created with marker and draw the contours on the bottle.

Step 6: Crop the Whole Piece Enclosing Forms

Picture of Crop the Whole Piece Enclosing Forms

Cut out the whole piece, inside of which there are your forms and only later more precisely, the single piece.

Step 7: Leveling the Piece

Picture of Leveling the Piece

With sandpaper try to finish the perimeter of your future rings; if you need to, you can use a lighter to "smooth" the edges.

Step 8: Start Coloring

Picture of Start Coloring

Work, with colors or gutta to begin to give life to your ring.

Step 9: Complete the Job and Wait for It to Dry

Picture of Complete the Job and Wait for It to Dry

Finish your work and let it dry completely.

Step 10: Glue the Piece to the Support

Picture of Glue the Piece to the Support

Once dry your piece, you can proceed. Then you put the glue on the support that you will put in a card, so as to keep it and put the piece above!

Step 11: Wear!

Picture of Wear!

Wait until completely dry out your new work and ... wear it!

Comments

About This Instructable

1,721views

12favorites

License:

Bio: First MakerSpace in Pisa. Since 2014.
More by Creiamo3D:Graduation Party FavorsCurly Woman (paper Quilling)Reuse Nespresso capsules
Add instructable to: