Instructables

Triple Single Bracelet

Picture of Triple Single Bracelet
ill show you how to make this beautiful bracelet
 
Remove these adsRemove these ads by Signing Up

Step 1: Placing your bands

Get your materials place the bands as shown in the picture when you get to the triangle make sure you skip one and keep going till and then go to the end and place a figure "8" band.

Step 2: Looming

Now turn your loom board around with the hooks facing in front of you and follow pictures
tip:you can hold the white part back its more easier to get the bottom band♥

Step 3:

grab the blue band and place it on the middle peg. Know do the same thing fot the other side make sure to push the bands down so they can fit

Step 4: Placing all three

Picture of placing all three
temp_633544320.jpg
temp_-1669170022.jpg
temp_546994489.jpg
temp_-1371875763.jpg
temp_742966024.jpg
grab the blue band and place it on the middle peg. Know do the same thing fot the other side make sure to push the bands down so they can fit

Step 5: Wrist Size

Put the loom stick through all of them if your wrist is small I suggest putting 4 or 6
if you have a bid wrist 6 or 9

Step 6: "C"clip

Put on your "C" clip and take it off SLOWY when you get to the end band grab it and put on the c clip
And there you bracelet is done
if you have any questions comment
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!