Introduction: True Knex Bullpup Sidearm

Picture of True Knex Bullpup Sidearm

This is a true bullpup with the trigger mech in the rear


Should I post?

Comments

sandroknexmaster (author)2015-04-18

Nice!

Knextremely stupid (author)2015-04-06

Sawyerznbetgeron then y don't u build one because I'm not sure what u mean

Knextremely stupid (author)2015-03-31

True bullpup means that the mech is behind the handle

On this gun the ram rod is blocked in the rear of the gun and the handle us moved forwards

The trigger is connected to the rear mech by a series of gears

I agree with everything Lucas the boss said, I have tried to build bullpup pistols in the past, but I had trouble with the trigger mech.

Dreamwave (author)CorgiCritter2015-04-01

how hard could it be? just have a top pull piece with two orange connectors attached to the trigger serving as the sides of the batter with a rotating block mech at the back. Don't try integrating it with gears as that would fail, just have a direct extension of the trigger through the sides of the barrel to a top rod, then figure out the back mech from there

CorgiCritter (author)Dreamwave2015-04-02

I know how to build the trigger, but incorporating it in a pistol that looks good and shoots well.

Lucas The Boss (author)2015-04-01

Ok your getting much better with knex, so I would start putting a good paragraph about the gun telling us why you made it and just about the gun. Second I would add either a pros and cons list or just a stats list. You made a bullpup pistol which is very hard to so so very good job!

About This Instructable

170views

1favorite

License:

Bio: Retired from instructables now. I am going over to YouTube so check me out at "knextreme productions"!
More by Knextremely stupid:The Saber Mk 2.0The Wolverine a K'nex Assault Rifle + VideoK'nex Competitor 5 Review
Add instructable to: