Introduction: Turnigy 9x Portable FPV Ground Station Assembly

Picture of Turnigy 9x Portable FPV Ground Station Assembly

My build steps are in the video. If you have any questions please reach out. I will be happy to help.

I applied CA glue in a few stages to various locations on the frame *TAKE YOUR TIME* let if dry!

Tip - I also applied a few small pieces of duck tape to the rear handle of my 9X to keep the frame clips from sliding on the smooth surface of the handle.

Comments

About This Instructable

477views

14favorites

License:

Bio: I am a builder and maker of things. I enjoy the command line, electronics, learning robotics, quad copters, and cooking food. I'd rather not ... More »
More by DougM65:Variable DC power module for your remote control "RC" hobby - DP50V5ATurnigy 9x Portable FPV Ground Station AssemblyHow I built this 200mm Mini H Quad Copter
Add instructable to: