Introduction: Twine Tomato Holder

  • All you need for this project is 3 T-Post,Twine,& a Knife It should take about 2 or 3 minutes for each Tomato Plant.

Step 1: Driving & Stringing the T- Post

  • 1. Get your T-Post & Driver drive all of the T-Post in a strait line & Tie a line from T-Post to T-Post.

Step 2: Cutting & Tying the Twine

  • 2. Cut your twine & tie a Figure 8.

Step 3: Draping & Attaching the Twine to the Tomato Plant

  • .3 Drape Twine over Twine attached to T-post, then attach Figure 8 to Tomato Plant, last tie Half Hitch to Tomato Plant.

Step 4:

Comments

author
DIY Hacks and How Tos made it! (author)2015-08-05

Cool project. If you upload the video to a video sharing site like YouTube, you can embed the video in the step so that people can watching on the same page as your instructions without having to download it.

author
ShadowRed made it! (author)ShadowRed2015-08-26

THX for the tip!

author
Lorrainecm5 made it! (author)2015-08-05

wish I knew where to buy the twine ):

author
Chicken Charmer made it! (author)Chicken Charmer2015-08-26

TSC or possibly at a art store

author
freezerboy620 made it! (author)2015-08-05

You are mean. That was when i was new to instructables and you said it was stupid

About This Instructable

530views

7favorites

License:

More by Chicken Charmer:Twine Tomato Holder
Add instructable to: