Introduction: Twist Earrings

Picture of Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

In this lesson you learn how to create earrings by using cylinder shapes. Let's get started!

  1. Drag a Cylinder shape to the workplane.

Step 1: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Scale it smaller to a diameter of 15mm.

Step 2: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Scale it smaller to a height of 2mm.

Step 3: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Rotate and move it to the area outlined in orange.
  2. Don't forget you can change the Snap grid from 1.0 to 0.25 for more control when positioning shapes.

Step 4: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Copy and paste it, then rotate the shape 60 degrees.
  2. Move it to the area marked in orange.

Step 5: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Copy and paste the new cylinder and rotate it 60 degrees.
  2. Move it to the area marked in orange.

Step 6: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Select all 3 cylinder shapes.
  2. Copy and paste them and move them to the area highlighted in orange.

Step 7: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

  1. Finish up by selecting all the shapes, except the earing attachment near the top, and group them into a single object.

Step 8: Twist Earrings

The following information is a single lesson in a larger Tinkercad project. Check out this and more projects on Tinkercad.

    Congratulations! You did it!

    Comments

    About This Instructable

    117views

    0favorites

    License:

    More by tinkercad-support:VEX IQ: Clawbot ScoopBalloon Powered CarExplore Buoyancy: Designing Sea Craft
    Add instructable to: