Print PDF
Favorite
Email
Step 3Turning a Larks foot into a two wrap prussic.
In this step widen the gap in the middle of the lark's foot. (refer to the first picture). This is a lot like retying the original larks foot except you are tying it through the middle.
Create a gap in the middle of the larks foot.
Pass the end through though the gap that you have created.
Tighten down and tidy it up if needs be.
I have reshot this sequence too, using the carabiner for clarity. Remember you want to be doing this with A rope rather than a biner, becuase well, this biner, even though one of the largest on the market is only 120MM high.
Create a gap in the middle of the larks foot.
Pass the end through though the gap that you have created.
Tighten down and tidy it up if needs be.
I have reshot this sequence too, using the carabiner for clarity. Remember you want to be doing this with A rope rather than a biner, becuase well, this biner, even though one of the largest on the market is only 120MM high.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
