Introduction: UAV Design and Construction

I will ıntroduce you about the my procedures while I construct the UAV for school project.

Step 1: Design Procedures

I have calculated wing area center of gravity drag lift thrust things and desssigned the plane by using this parameters in sketch-up program.

Step 2: Wing and Body Cutting

I used foamboard as a main material to construct my UAV. And to give shape the foam ı used hot wire cutting method by resistance wire.

Step 3: Assembling of Wing and Body With Electronics

Step 4: The Video System

Step 5: Last Checks and Pose With My UAV :)

Comments