Print PDF
Favorite
Email
Step 3Bore the Cigar
This part is very critical. it is not easy to bore a cigar !
The goal is to bore the cigar through in order to harden the inside with primer (next step).
Use drill bits of increasing diameter.
Start with a thin drill bit, using a drill stand for perfect alignment. Drill from each end.
Continue with increasing diameters, but no more than the half of the cigar diameter. Use a cordless drill/screwdriver on lowest speed.
Keep some tobacco dust for later.
The goal is to bore the cigar through in order to harden the inside with primer (next step).
Use drill bits of increasing diameter.
Start with a thin drill bit, using a drill stand for perfect alignment. Drill from each end.
Continue with increasing diameters, but no more than the half of the cigar diameter. Use a cordless drill/screwdriver on lowest speed.
Keep some tobacco dust for later.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
