Introduction: USB Drive Butterfly Knife

Picture of USB Drive Butterfly Knife

 Do you want to show off your balisong tricks to your friends in school?
Are you looking for a cooler flash-drive?
FUNKYYYYYYYYY       TIMEEEEEEEEE!!!!!

Comments

awesomeguy1235 (author)2011-05-05

nice, how do i make it?

MadBricoleur (author)2010-07-12

really nice. =)

Doomog (author)2010-03-25

How did you form the platform for the pins AND make it stay to the naked chip?

skaterqwertyuiop (author)Doomog2010-03-25

 I cut and drilled a piece of scrap metal. it looked like this- (o   o)
Before i glued it to the drive, i put a layer of glue down and waited for it to harden (so the metal would not connect the parts of the drive). Then I glued the metal piece onto the hardened glue.
I used a very powerful glue, I'll write the name later. 

About This Instructable

6,770views

18favorites

License:

Bio: Young and creative kid turned mechanical engineering student at University of Pittsburgh. All posts here were posted when I was in highschool. New projects coming ... More »
More by skaterqwertyuiop:Repair broken helmet visorHow to clean a hydration bladderLightsaber
Add instructable to: