Hi friends,
im new in instructables and this is my first project in instructables
The circuit is very simple.
what all things you need are;
1. two cool white LEDs
2. One green LED
3. 120Ω resistor
4. some wires
5. a USB male pin
im new in instructables and this is my first project in instructables
The circuit is very simple.
what all things you need are;
1. two cool white LEDs
2. One green LED
3. 120Ω resistor
4. some wires
5. a USB male pin
Remove these ads by
Signing UpStep 1:
Circuits can be done as per the circuit diagram
NOTE:
The wires from both the ends of a USB pin are its positive and negetive (red and black wires).
Green and White(middle two) are wires for data.don't connect these wires
For Making the Body:
Things required are;
1. flexible pipe ( I detached it from an old table lamp)
2. a reflector ( from an old torch)
3.The thing shown in red marker in the picture (detached from play station 2 dual shock controler)
(i don't know its name. whatever, im calling it a Wieght holder)
NOTE:
The wires from both the ends of a USB pin are its positive and negetive (red and black wires).
Green and White(middle two) are wires for data.don't connect these wires
For Making the Body:
Things required are;
1. flexible pipe ( I detached it from an old table lamp)
2. a reflector ( from an old torch)
3.The thing shown in red marker in the picture (detached from play station 2 dual shock controler)
(i don't know its name. whatever, im calling it a Wieght holder)
Visit Our Store »
Go Pro Today »
the chance of failure is very less ,even if it is so, LEDs are very cheap no??