Print PDF
Favorite
Email
Step 4Prepare the plug.
Take your USB plug and cut off the end that will not easily plug into your computer. It should look like the picture below. The red and black wires are the ones that you will be concerned with later. Red is +5V and black is ground.
Once your wire is cut, make a hole in the side of the apple towards the base as thick as the wire. This hole should bore through until it hits the cylindrical hole you have already carved out. You can do this very carefully with a drill or an awl. Once the hole is complete, pass the wire through.
Once your wire is cut, make a hole in the side of the apple towards the base as thick as the wire. This hole should bore through until it hits the cylindrical hole you have already carved out. You can do this very carefully with a drill or an awl. Once the hole is complete, pass the wire through.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
