Print PDF
Favorite
Email
Step 6CUT THE SENSOR BOARD
The sensor board included in the DIY Kit is longer than the crossbar on your typewriter. That is because it is designed to be cut to length. Using tin-snips, wire strippers, or scissors, cut the sensor board so that it is the same length as the crossbar.
Unless they are very sharp, the scissors won't cut the board very easily, so go slow.
IMPORTANT: Make sure you save the scrap you cut off -- it will come in handy later!
Unless they are very sharp, the scissors won't cut the board very easily, so go slow.
IMPORTANT: Make sure you save the scrap you cut off -- it will come in handy later!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
