Print PDF
Favorite
Email
Step 2Assemble+TEST
Drill 3 holes into the Bay Cover.
Two on one side about 1/2 inch apart
One on the far side of the Bay Cover, across from the other two, preferably between them.
We are only using the RED (5v) and the BLACK (GND) wires for this.
Cut the BLACK wire and strip a length of it on both sides of your cut (just enough to solder).
Cut the RED wire and do the same.
Now, place the finishing nails (or whatever you are using) through the holes from the bottom of the Bay Cover.
Solder both ends of the BLACK wire to the solitary nail.
Solder each of the RED wires to ONE of the nails.
*TEST YOUR CONNECTIONS BEFORE MOVING ON!!!
Two on one side about 1/2 inch apart
One on the far side of the Bay Cover, across from the other two, preferably between them.
We are only using the RED (5v) and the BLACK (GND) wires for this.
Cut the BLACK wire and strip a length of it on both sides of your cut (just enough to solder).
Cut the RED wire and do the same.
Now, place the finishing nails (or whatever you are using) through the holes from the bottom of the Bay Cover.
Solder both ends of the BLACK wire to the solitary nail.
Solder each of the RED wires to ONE of the nails.
*TEST YOUR CONNECTIONS BEFORE MOVING ON!!!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
