Attach wires to breakout board

Step 3: Attach wires to breakout board

In order to attach the wires to the breakout board, follow these steps:

1) Cut one piece of red wire approximately 6 inches long.
2) Cut one piece of green wire approximately 6 inches long.
3) Strip only one end of each of the two wires that you've cut
4) Secure the breakout board so that the wires can be soldered to the breakout boards.
5) Thread the stripped red wire through the back of the breakout board, through the hole that corresponds to VCC.
6) Thread the stripped green wire through the back of the breakout board, through the hole that corresponds to GND
7)Solder both wires to their corresponding contacts
8)Clip the excess lead when the solder has cooled.