Print PDF
Favorite
Email
Step 5Assemble / Gape and genuflect
All three layers are now done - time to make a big green sandwich. Assembly is straight forward: Top layer on top, acrylic under that, PCB next.
A picture of my first UVIL assembly is below.
Also is a (wiggled, blurry) picture of the Olivian UVIL backside showing the roller limit switch I added so that you can turn it off just by laying it down. I wanted to use a tadly mercury switch but didn't have one on hand. Incidentally, The Olivian UVIL bottom PCB also used a sharpie pen as resist (rather than toner transfer)
A picture of my first UVIL assembly is below.
Also is a (wiggled, blurry) picture of the Olivian UVIL backside showing the roller limit switch I added so that you can turn it off just by laying it down. I wanted to use a tadly mercury switch but didn't have one on hand. Incidentally, The Olivian UVIL bottom PCB also used a sharpie pen as resist (rather than toner transfer)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
