Target for Your Knex Gun





Introduction: Target for Your Knex Gun

A good and sturdy knex target. This will take you no longer than five minutes to make. There arent many good knex targets on instructables for you to use your knex guns on so i decided to post the target i use. Id like to know what you think about it, so please comment(dont be too harsh on me this is my first instructable).

Step 1: The Actual Target

very simple. you dont have to be a genius to do this.

Step 2: The Thing That Holds Up the Target

i dont think i need to write any instructions here.

Step 3: Another Part

Again this is supa easy.

Step 4: The Base

Nice and strong(just in case i aim a bit to low). Nice and wide so that it stays upright.

Step 5: Put Together and Add the Rubber Band.

pic1- place the rubber band like this. you can adjust the tightness if the rubberband depending on whether you want the rubberband to just stop the target from smashing into the ground, or if you want the target to bounce back up. YOu can see that i have the rubberband on very loosely.
pic2-it should look look this when your done.



    • Pocket-Sized Contest

      Pocket-Sized Contest
    • Pro Tips Challenge

      Pro Tips Challenge
    • Paper Contest 2018

      Paper Contest 2018

    We have a be nice policy.
    Please be positive and constructive.




    my knex slingshot rifle broke the knex plate in half after two shots

    Good target, nice and sturdy, but a little to big, any gun could easily hit that, so it wont help prove the accuracy of any gun. make the square thing a lot smaller, then i'll give you a 5, for now, a 3.5 will do. Great job!

    nice and clean. good guns will bust the panel, though.

    Yep! Mine did I can't remeber exactly, but I think it was my own little crossbow thing, if you want to see pics I will post them in your orange board.