Introduction: Underwater Mask for Gopro Hero, Using Mask, Joint and 3 Sugrus

Picture of Underwater Mask for Gopro Hero, Using Mask, Joint and 3 Sugrus

We get a long joint, then cut its two edges, then use the iron to smooth it out, use pliers to clean iron
then clean the surfaces , make a ball of Sugru using three packs
then put the joint in the ball then put the ball on the mask and start shaping to get the final
form where u notice it stretches on both front and back sides down.

This was done during Lamba Labs Beirut Hackerspace Build Night.

Comments

BABLOON1424 (author)2013-07-31

Like your go pro?

فوزنه (author)BABLOON14242015-05-29

Yes I do, and after a year of using it and the Mask mount, it still works :)

About This Instructable

1,152views

12favorites

License:

More by فوزنه:Underwater Mask for Gopro Hero, using Mask, joint and 3 SugrusGoPro hero3 Frame using Case of battery backpack, 2 Sugrus and a joint
Add instructable to: