CNC - Unitronics Controller Assembly

1,353

13

2

Published

Introduction: CNC - Unitronics Controller Assembly

About: Hello, I'm working at large scale high-tech company. As part of my responsibility, I provide professional support for most electrical & electronic development activities in the company: • Planning, impleme...

This controller was made as a final project of my electrical studying.
There are 10 D/I and 10 D/O that allow switch electrical devices
(like motors, heaters, etc.) with continuous current up to 8A (230VAC).
Main parts:
Controller - Unitronics V120-22-R34.
VIP – Voltage/Current/Power metter.
PS – TDK 24VDC / 4A.
10 Relays – 24VDC (230VAC / 8A).
Enclosure BI-4 – 350/250/130mm (IP55).
Toggle switches, reset buttons, red lamps,  "banana" sockets.
Front panel made aluminum 2mm.
All the milling works were performed on Roland EGX-350 CNC machine.

Share

    Recommendations

    • Oil Contest

      Oil Contest
    • Clocks Contest

      Clocks Contest
    • Creative Misuse Contest

      Creative Misuse Contest

    2 Discussions