Instructables
Picture of Upcycled glowing Toilet plunger Lamp!
Turn this cool looking toilet plunger into a modern looking lamp.

Step 2: Drill hole in plunger.

Picture of Drill hole in plunger.
Drill a small hole in the center on top of the pluger.

Step 3: Unsrew Top of plunger.

Picture of Unsrew Top of plunger.
Unscrew plunger and insert lamp cord through the hole ontop of plunger. Pull the cord till it is at least 2" out of the top of plunger and inside the bottem half.

Step 5: Secure lamp socket to lamp cord.

Thread lamp cord through plunger. lamp cord has a smooth wire which should connect to golden screw on socket and other wire connects to the other screw. I put hot glue on top of screws so not to get socked later. Screw CFL light bulb in.

Step 6: Heat release holes.

Drill 4 small holes in the top of the bottom half of plunger above the socket (just to be on safe side.)

Step 7: Secure cord to plunger.

Picture of Secure cord to plunger.
Pull lamp cord up through plunger till the hole in the lamp cord is next to the hole in the middle of the plunger. Thread zip tie through and pull secure. Snip zip tie. Srew plunger together.

Step 8: Hang and plug in!

Picture of Hang and plug in!
Hang your new light and plug in.
 
Remove these adsRemove these ads by Signing Up