Instructables

Make a PC Gaming Headset to Xbox 360 Adapter

Step 6: Ready, Set, SOLDER!

1) On Side A (red), solder your ground wire from the back where it was threaded through, all the way around.

2) On Side A (red), solder the point where the red wire connects to the terminal and snip off the remaining black wire ensuring that none of the black wire will come in contact with any of the other wires or solder.

3) On Side B (black), solder your ground wire from the back where it was threaded through all the way around.

4) On Side B (black), solder the point where the black wire connects to the terminal and snip off the remaining red wire ensuring that none of the red wire will come in contact with any of the other wires or solder.

5) On Side B (black), create a bridge out of a small piece of wire and connect both terminals together. Note, this is only done on the BLACK side. This is going to cause you to have pseudo Stereo sound as you're really diverting the mono signal to go through both sides of your head phones.
 
Remove these adsRemove these ads by Signing Up
nk dtk3 years ago
on this picture, is the black wire on the left and the red wireon the right cut down and un used?
thanks
~alex
poolgirlblue (author)  nk dtk3 years ago
correct. one side is mic, the other is audio. you isolate one on each side so that you can plug in the mic(red) and the headphones(black).
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!