Step 8: Finishing touches
Solder zip wires from the power-carrying plugs to the capacitor and the resistor. Protect with heat shrink tubing and attach each to one end of the LED chain.
Space IS tight, so only use as much wire as is needed.
The long green bundle under the cap is the resistor assembly.
The cap is linked to the other end of the LEDs with the red wire.
The big arrow is to make sure I don't start operating on the wrong end of the patient!
Make sure everything is tight and reassemble.
Space IS tight, so only use as much wire as is needed.
The long green bundle under the cap is the resistor assembly.
The cap is linked to the other end of the LEDs with the red wire.
The big arrow is to make sure I don't start operating on the wrong end of the patient!
Make sure everything is tight and reassemble.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
