Instructables

Step 6: Stock

Picture of Stock
VSS 6.1.JPG
VSS 6.2.JPG
VSS 6.3.JPG
VSS 6.4.JPG
VSS 6.5.JPG
VSS 6.6.JPG
VSS 6.7.JPG
VSS 6.11.JPG
VSS 6.12.JPG
VSS 6.9.JPG
VSS 6.10.JPG
This is the stock. I used the bronze half-moon connectors to make it look like wood, but you don't have to use them if you don't want to.

Pictures:
1. What you are making.
2. Make.
3. Add second layer.
4. A close up of what the the strut in the stock should look like.
5. Add third layer.
6. Add fourth layer, same as third.
7. Add fifth layer, same as second.
8. Add sixth layer, same as first.
9-12. What it should look like.
 
Remove these adsRemove these ads by Signing Up
dan3354 years ago
I don't think the stock needs to be this complicated. I made a much simpler Version coz i was low on mini-rods
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!