Introduction: Vibrobeast

Picture of Vibrobeast

This 24 legged beast named Vibrobeast also known as vibrobot spins a gear that makes it virbrate.
It's very easy to make because only needs a few materials and doesn't need any programming and other stuff.

Please rate and comment :D

Step 1: Materials

Picture of Materials

The materials that are needed are:

-IC (doesn't matter how many pins)
-Wide gear
-9v battery
-Battery clip

-Glue gun

Step 2: Customizing the Gear and Gluing

Picture of Customizing the Gear and Gluing

First get your pliers and gently break the gear in half and glue it on the motor.Next is glue the IC and the motor together.
Get your pliers and take the strip off the insulator of the battery clip and twist them on the motor.

Step 3: More Gluing :D

Picture of More Gluing :D

Add glue on top of the motor and place the battery


twturley47 (author)2011-07-04

Great job. Good photos Would never thought of using a EEPROM for a brissel bot. Would also love to see a vid.

Kiteman (author)2011-07-02

Nice job!

Any chance of a video of it dashing about the table?

tobyscool (author)Kiteman2011-07-02

I am going to post a video tomorrow need to charge it

Kiteman (author)tobyscool2011-07-02


About This Instructable




Bio: I am 12 years old and like to make things
More by tobyscool:VibrobeastHow to Spin a Toothbrush on your fingerGB cartridge case
Add instructable to: