Virtual Dice Using Arduino

950

6

Posted

Introduction: Virtual Dice Using Arduino

This is a virtual dice. It requires the following items:

10x     Jumper Wires
7x       LEDs
7x       330 Ohm Resistors
1x       10k Ohm Resistor
1x       Button
1x       Breadboard or Perfboard
1x       Arduino Mega 2560 or Arduino Uno

This project takes about 30 minutes to an hour to make.

This is the code that I used:

int pinLeds1 = 10;
int pinLeds2 = 9;
int pinLeds3 = 7;
int pinLed4 = 8;
int buttonPin = 6;
int buttonState;
long ran;
int time = 2000;

void setup ()
{
  pinMode (pinLeds1, OUTPUT);
  pinMode (pinLeds2, OUTPUT);
  pinMode (pinLeds3, OUTPUT);
  pinMode (pinLed4, OUTPUT);
  pinMode (buttonPin, INPUT);
  randomSeed(analogRead(0));
}

void loop()
{
  buttonState = digitalRead(buttonPin);
  if (buttonState == HIGH){
    ran = random(1, 7);
    if (ran == 1){
      digitalWrite (pinLed4, HIGH);
      delay (time);
    }
    if (ran == 2){
      digitalWrite (pinLeds1, HIGH);
      delay (time);
    }
    if (ran == 3){
      digitalWrite (pinLeds3, HIGH);
      digitalWrite (pinLed4, HIGH);
      delay (time);
    }
    if (ran == 4){
      digitalWrite (pinLeds1, HIGH);
      digitalWrite (pinLeds3, HIGH);
      delay (time);
    }
    if (ran == 5){
      digitalWrite (pinLeds1, HIGH);
      digitalWrite (pinLeds3, HIGH);
      digitalWrite (pinLed4, HIGH);
      delay (time);
   }
   if (ran == 6){
      digitalWrite (pinLeds1, HIGH);
      digitalWrite (pinLeds2, HIGH);
      digitalWrite (pinLeds3, HIGH);
      delay (time);
   }
  }
  digitalWrite (pinLeds1, LOW);
  digitalWrite (pinLeds2, LOW);
  digitalWrite (pinLeds3, LOW);
  digitalWrite (pinLed4, LOW);
}

Share

Recommendations

  • Epilog Challenge 9

    Epilog Challenge 9
  • First Time Author Contest 2018

    First Time Author Contest 2018
  • Paper Contest 2018

    Paper Contest 2018
user

We have a be nice policy.
Please be positive and constructive.

Tips

Questions

Comments