Introduction: WHEEL BALANCING

Picture of WHEEL BALANCING


Step 1:

Picture of

Step One

Static
"Wheel Balancing"
Equipment by Snap-On

Step 2:

Picture of

Step Two

Equipment with
"Counter Balance"
In Place

Step 3:

Picture of

Step Three

Snap-On
Data Plate
(Enlarged to some degree)

Step 4:

Picture of

Step Four

Equipment with
"Protractor"
In Place(Divides
Assembly into One-Thirds)

Step 5:

Picture of

Step Five

Hub & Drum Mounted.
Heavy Spot Marked at
Bottom with Chalk

Step 6:

Picture of

Step Six

Hub & Drum
Counter Balanced
with 2.75 Ounces

Step 7:

Picture of

Step Seven

Tire and Wheel Mounted.
Heavy Spot Marked at
Bottom with Chalk

Step 8:

Picture of

Step Eight

Tire and Wheel
Counter Balanced
with 2.75 Ounces

Step 9:

Picture of

Step Nine

Hub & Drum, Tire & Wheel
Mounted with Heavy Ends
Opposite Each Other Best
Possible. Note White Chalk
on Drum at Bottom, &
Chalk Mark on the Tire
at Upper Right

Step 10:

Picture of

Step Ten

Complete Assembly
Mounted Showing
New Heavy Spot at
Right Arrow and
Counter Balanced
with 4 Ounces

Step 11:

Picture of

Step Eleven

Complete Assembly
with Protractor in Place
Dividing Wheel into
120 Degree Sections.
Note Arrow at Bottom &
Marks at Upper Left
and Upper Right

Step 12:

Picture of

Step Twelve

Lead Weights
In Place
at 120 Degrees
from
Heavy Spot

Step 13:

Picture of

Completion

Balancing
Completed

Comments

About This Instructable

6,671views

6favorites

License:

More by bolshoy_plohish:Power hammerWHEEL BALANCINGUnicorn Log Splitter
Add instructable to: